Assembly Instructions can be found HERE!
Includes:
1 x Duo2Go rev2 WiFi Pixel Controller
2 x 100ct 12V Resistor Bullet Pixels (xConnect)
1 x Genuine Meanwell LRS-150-12 (12.5A) Power Supply
2 x Flat 3-wire Pigtails (Female xConnect)
1 x 3-core 18awg power cord (NEMA15)
1 x 2-core 16awg power wire
Everything you need to get your blinky on!
It's a wonderful kit for pros and beginners alike
Kit will come shipped with the proper phoenix connectors attached to the female pigtails.
The female pigtails will come already attached to the pixel strings. Assembly couldn't be easier!
Jason did an unboxing video and walked through basic setup on a PPD webinar. If you are curious to see how easy these are to set up, click HERE to watch!
David Henry, from Learn Christmas Lighting also did an unboxing on his Youtube channel! Check it out HERE!
-----
Runs WLED 0.15.0 software, pre-installed
Supports 512 pixels per channel for 40fps
Supports 800 pixels per channel for 30fps
Supports 1000 pixels per channel for 15-20fps
(In order to use more than 400 pixels (200 on each output) , you will most likely need to use some form of voltage injection or reduce brightness to avoid overloading the 5A fuses)
