Controllers

In stock and ready to ship! 2-Port Pixel Controller Revision 2.0 Great for beginners! 2.4 GHz Wi-Fi only ESP32 Based WLED 0.14.4 pre-installed(Open Source Software - MIT License)https://github.com/Aircoookie/WLED XLights Compatible...

In stock and ready to ship! 4-Port Pixel Controller (upgradable to 8-Port w/ the Differential Module) Revision 1.1a Wi-Fi support (2.4GHz only) ESP32 Based Expansion header (Ethernet, Differential, SD Card...

REQUIRES a Tetra2Go - Sold Separately (NOT compatible with the Duo2Go controller)10/100 Mbps Wired Ethernet ModuleLAN 8720 Chipset Requires Ethernet-ready image of WLED (included when purchased with Tetra2Go)Downloadable here: WLED_0.14.0_Tetra_Ethernet.binUse the "ESP32Deux" Ethernet type...

REQUIRES a Tetra2Go - Sold Separately (NOT compatible with the Duo2Go controller)INMP441 Digital Output Sensor Module MEMS High Precision Omnidirectional Microphone Sensor Module for the Tetra2Go Requires Audio-Reactive image of WLED (included when purchased with...

SD card not included REQUIRES a Tetra2Go - Sold Separately (NOT compatible with the Duo2Go controller) Requires ESPixelStick pre-release firmware. (Tested with ci8941219760)Download HereThe SD card module allows you to save sequence...

Blue and Yellow, 0.96 inch OLED4-pin I2C Interface(GND, VCC, SCL, SDA) Resolution is 128 x 64; View angle is more than 160 degrees; Supporting voltage is from 3.3V to 5V...

REQUIRES a Tetra2Go and a Differential Receiver - Sold Separately (NOT compatible with the Duo2Go controller)(Not "Smart" mode compatible! Can not be daisy chained.)Currently tested with Falcon v1.01 Receivers - will be testing...

The DAC is an amazing multipurpose device!It's most popular use is allowing you to attach your dumb RGB pixels to your WS281x controller.  Simply attach the board on to the controller...

Take ANY pixel port on ANY controller and turn it into a single differential port!Transmitter converts pixel data to a differential signal via it's MAX485 chip.Receiver converts the differential signal...

Pre-Order yours now! 8-Port Pixel Controller  Revision 1.0 Wi-Fi support (2.4GHz only) ESP32 Based Expansion header (Ethernet, SD Card and Audio-Reactive Modules available, sold separately) WLED 0.14.4 pre-installed(Open Source Software...

REQUIRES a Tetra2Go or Octa2Go - Sold Separately (NOT compatible with the Duo2Go controller) Elevate your lighting control with this versatile 4-Button Add-On Module, designed specifically for use with the Tetra2Go and...

SN74AHCT125-Based Level Shifter - 3.3V to 5V (Ideal for WS2811) Please Note! These are NOT modules for use with the Tetra or Octo2Go controllers!They are intended for those who wish...