Solo2Go 1-Port Wi-Fi Pixel Controller

$29.99 USD $25.00 USD

apple paymasterpaypalshopify paysofortvisa
SKU:
Availability: In Stock Pre order Out of stock
Description

  • 1-Port Pixel Controller (upgradable to 8-Port w/ the Differential Module)
  • Revision 1.0
  • Wi-Fi support (2.4GHz only)
  • ESP32 Based
  • Expansion header (Ethernet, Differential, SD Card, 4-Button, IR Receiver and Audio-Reactive Modules available, sold separately)
  • WLED 0.15.0 pre-installed
  • XLights Compatible
  • 5V Data Signal, 33 ohms
  • Modular and repairable
  • Supports 24v, 12v & 5v pixels and strip (3 pin only, no CLK)
  • Runs WLED software, pre-installed
  • Dimensions: 33mm x 98mm (roughly 1.5" x 4")
  • 5A MAX per output. (5A Total)
    (Over 200 LEDs per output should only exceeded only with proper voltage injection or reduced brightness)

  • NOTE - Due to size constraints,. there is NO REVERSE POLARITY PROTECTION on the Solo2Go - Always double-check your power wiring!!! Reversed polarity will damage your controller and your lights.

  • How many pixels can it support?
    The ESP32 can calculate about 65k-85k LEDs per second (that means 1000 LEDs @~70fps, 2000 LEDs @~35fps, 4000 LEDs @~18fps)

    * For excellent performance, it is recommended to use 400 pixels/output  (RECOMMENDED)

    *For very good performance, it is recommended to use 600pixels/output
    *For good performance, you can use 800 pixels/output 
    *For okay performance, you can use 1000 pixels/output


    Outputs

    Port1: GPIO2