In Stock Items

Designed to assist in increasing the data signal with longer distances between a controller and the pixels Can be used with 5V or 12v xConnect connectors Male end is the...

A quick and easy way to test your pixels and help you diagnose controller issues.This product does NOT include a 12v or 5v power supply.  Power must be supplied via...

250V 10A 16awg~28awg 3.81mm 1x3P Green Plug P=3.81mm Pluggable System Terminal Block ROHS

SD card not included REQUIRES a Tetra2Go - Sold Separately (NOT compatible with the Duo2Go controller) Requires ESPixelStick pre-release firmware. (Tested with ci8941219760)Download HereThe SD card module allows you to save sequence...

Male xConnect ConnectorFlat 3-wireMarked as 18AWG, but closer to 20AWG 10cm long (~4 inches)

IP Rating: IP66 Input Voltage: DC 12V Warranty: 1-Year Working Temperature: -20℃-80℃

Tired of sore and blistered fingers? These pliers can help! Designed to help you push 12mm bullet pixels into your props and strips.

Length: 5 metersLEDs per meter: 60 (300 LEDs total / 100 nodes)Color Order: GRBVoltage: 12V (WS2811)IP66 Rated (Strip in plastic sleeve - NOT silicone-filled)xConnect pigtails Please note that this type of...

*These are the controllers used on the Tetra2Go 1.X Features PCB-mounted antenna 240MHz Dual-Core Processor Wi-Fi + Bluetooth 4.0 + BLE module 4MB (32Mbit) Flash Memory Onboard USB Type-C connector...

Blue and Yellow, 0.96 inch OLED4-pin I2C Interface(GND, VCC, SCL, SDA) Resolution is 128 x 64; View angle is more than 160 degrees; Supporting voltage is from 3.3V to 5V...

Tired of the look of PVC mounted to your gutters? Ready for an economical, low-profile solution that allows you to keep your roofline pixels up all year? If so - PixelTrak is...

REQUIRES a Tetra2Go and a Differential Receiver - Sold Separately (NOT compatible with the Duo2Go controller)(Not "Smart" mode compatible! Can not be daisy chained.)Currently tested with Falcon v1.01 Receivers - will be testing...