Ready2Go Starter Kit - 2-Port
Ready2Go Starter Kit - 2-Port
Description
A complete 2-port pixel controller kit for getting your display running without piecing everything together yourself. The controller, power supply, pixels, wiring, and connectors are all included and matched to work together.
Beginner friendly: the female pixel pigtails arrive connected to the pixel strings, and the correct Phoenix connectors are already attached. View the assembly instructions, connect your pixels, and start making them blink.
What’s included
- 1 × Duo2Go rev2 WiFi Pixel Controller
- 2 × 100-count 12V resistor bullet pixel strings with xConnect connectors
- 1 × Genuine Mean Well LRS-150-12 12.5A power supply
- 2 × Flat 3-wire female xConnect pigtails
- 1 × 3-core 18 AWG NEMA 5-15 power cord
- 1 × 2-core 16 AWG power wire
Ready to build with
This kit is a practical fit for both first-time pixel users and experienced decorators who want a clean, ready-to-assemble starting point. With two controller outputs and two 100-count pixel strings included, it is ready for a straightforward two-prop display or a small layout you can build on later.
Watch it come together
Watch Jason’s RGB2Go/PPD webinar walkthrough for an unboxing and basic setup of the Ready2Go kit.
The following walkthroughs feature the 4-Port Ready2Go Starter Kit, but the included power supply, wiring, pixels, and basic assembly steps are very similar to this 2-Port kit. The controller-output setup shown will differ.
Controller performance
- RGB2Go-compiled WLED 0.16.0.1 pre-installed
- Up to 512 pixels per output at 40 FPS
- Up to 800 pixels per output at 30 FPS
- Up to 1,000 pixels per output at 15–20 FPS
Planning larger runs: Above 400 total pixels (about 200 per output), plan on voltage injection or reduced brightness to avoid overloading the 5A output fuses.
Important: Complete all low-voltage wiring before connecting the power supply to AC power. Follow the power-supply and assembly instructions carefully.
Reviews
No review