Ready2Go Starter Kit - 1-Port
Ready2Go Starter Kit - 1-Port
Description
A complete single-port pixel controller kit for getting your first display running without piecing everything together yourself. The controller, power supply, pixels, wiring, and connectors are all included and matched to work together.
Beginner friendly: the female pixel pigtail arrives connected to the pixel string, and the correct Phoenix connector is already attached. Follow the assembly instructions, connect your pixels, and start making them blink.
What’s included
- 1 × Solo2Go WiFi Pixel Controller
- 1 × 100-count 12V resistor bullet pixel string with xConnect connector
- 1 × Genuine Mean Well LRS-150-12 12.5A power supply
- 1 × Flat 3-wire female xConnect pigtail
- 1 × 3-core 18 AWG NEMA 5-15 power cord
- 1 × 2-core 16 AWG power wire
Ready to build with
This kit is a practical fit for first-time pixel users and decorators who want a clean, ready-to-assemble starting point. It gives you a simple, single-output setup that is easy to learn and ready for a 100-pixel display.
Watch it come together
These walkthroughs feature the 4-Port Ready2Go Starter Kit, but the included power supply, wiring, pixels, and basic assembly steps are very similar to this 1-Port kit. The controller-output setup shown will differ.
Controller performance
- WLED 16.0.1 pre-installed
- Compatible with xLights and FPP
- ESPixelStick firmware available upon request
- Up to 512 pixels per output at 40 FPS
- Up to 800 pixels per output at 30 FPS
- Up to 1,000 pixels per output at 15–20 FPS
Planning larger runs: Above 200 pixels, plan on voltage injection or reduced brightness to avoid overloading the 5A output fuse.
Important: Complete all low-voltage wiring before connecting the power supply to AC power. Follow the power-supply and assembly instructions carefully.
Reviews
No review